LOADING...
Klark-teknik SQ1D SQ1D Eight Channel Dynamics Processor Details:
The Dynamics Processor shall provide eight complete channels of eithercompression or gating, with push button selection and LED status indicationof operational mode on anindividual channel basis. The compressor section on each channel shallprovide for adjustment of Threshold, Make-Up Gain, Attack and Release timesand Ratio. There shall be push button selection of RMS or Vintage Emulation(Peak) response and push button selection of Soft or Hard knee mode on eachchannel.
Description:
The Dynamics Processor shall provide eight complete channels of either
compression or gating, with push button selection and LED status indication
of operational mode on an
individual channel basis. The compressor section on each channel shall
provide for adjustment of Threshold, Make-Up Gain, Attack and Release times
and Ratio. There shall be push button selection of RMS or Vintage Emulation
(Peak) response and push button selection of Soft or Hard knee mode on each
channel.
The gate section on each channel shall provide for adjustment of Threshold,
Attack, Hold and Release times and Range. The Threshold, Attack and Release
controls
shall be operable by the same rotary control knobs in compression and gating
modes. Control of Ratio and Range shall be performed using the same rotary
control
knob. There shall be individual rotary control knobs for Make-Up Gain and
Hold. Each channel shall have a six-segment input
level meter and a ten-segment attenuation depth meter, which will show the
gain reduction being applied in both compression
and gating modes. Each channel shall have a sidechain bandpass filter with a
rotary control knob for frequency control and shall be enabled by
a push button switch. The band-pass filter shall have two different
bandwidth settings, selectable by a push button switch. There
shall be provision for an external sidechain input selected by the External
Key switch with LED status indication.
The Bypass switch shall set the signal path to unity gain on each channel
and provide LED status.
Each channel shall have a Solo switch with LED status indication that sends
the sidechain signal to the Solo Bus Output connector.
A Solo Bus Input connector shall allow multiple Dynamics units to be chained
together to form a common Solo
Bus Output. The Side Chain Solo In Place switch shall have LED status
indication and change the function of each Solo switch; when selected
the sidechain signal shall be sent to the channel output connector instead
of the Solo Bus Output.
The Dynamics Processor shall have the ability to link the operation of any
number of adjacent channels, which shall all be summed
into the sidechain of the left-hand linked channel which shall control the
gain of each of the linked channels. The selection of
either compression or gating for the left-hand linked channel shall override
the push button settings for all channels linked to it.
A Power On Led shall be provided.
The Dynamics Processor shall meet or exceed the following specifications:
Distortion: (THD+N) <0.02% @1kHz, +4dBu; Frequency response: ±0.5dB
(20Hz-20kHz); Dynamic Range (20Hz-20kHz unweighted) >117dB.
Each channel shall have XLR connectors for the input and output and a 1/4”
TRS jack socket for the external side chain input. All audio connections
shall be electronically balanced.
The Dynamics Processor shall be 19” standard rack mountable and 3U high.
The Dynamics Processor shall be capable of operating from a 100-240V ±10%
50/60Hz a.c. power source.
The Dynamics Processor shall be the Klark Teknik Square ONE Dynamics, and no
alternative specification option is available.
Specifications:
* Dynamics Inputs Eight
* Type Electronically balanced XLR (pin 2 hot)
* Impedance (O) 10k
* Ext Key Inputs Eight
* Type Electronically balanced TRS Jack (Tip hot)
* Impedance (O) 20k
* Solo Bus Input One
* Type Electronically balanced XLR (pin 2 hot)
* Impedance (O) 20k
* Dynamics Outputs Eight
* Solo Bus Output One
* Type Electronically balanced XLR (pin 2 hot)
* Minimum load impedance 600O
* Source impedance <60 O
* Maximum level +22dBu into >2kO
* Performance
* Frequency response 20Hz – 20kHz ±0.5 dBu
* Distortion (THD+N) <0.02% @ 1kHz, +4 dBu
* Noise Floor <-95 dBu @ Unity Gain
* Dynamic range (20Hz-20kHz unweighted) >117 dB
* Compressor
* Threshold (Hard Knee) -50dB to +25dBu
* Gain 0dB to +30dB
* Attack 100us to 20ms
* Release 50ms to 2.5s
* Ratio 8 to 1:
* Gate
* Threshold -50dB to +25dBu
* Attack 10µs to 10ms
* Release 2ms to 2s
* Hold 2ms to 2s
* Range 8 to 0dB
* Sidechain Bandpass filter
* Frequency Range 40Hz -16kHz
* Slope (Wide) 6dB per Octave
* Terminations
* Audio 3-pin XLR and 1/4” TRS jack
* Power 3-pin IEC
* Power Requirements
* Voltage 100V-240V a.c. ± 10%
* Consumption <35W
* Dimensions
* Height 133mm (5.25 inch) – 3U High
* Width 482mm (19 inch)
* Depth 205mm (8 inch)
* Weight
* Nett 4.4kg
* Shipping 5.4kg
The Klark-teknik SQ1D SQ1D Eight Channel Dynamics Processor Includes:
Brand New With 1 Year USA Warranty
Shipping
- Ground: FREE SHIPPING
- Add to cart for extra saving and discounts
Ground Delivery (7-10 Days):
Ground Delivery is basic shipping service. The product will be shipped out via UPS, USPS, DHL or Fedex. For oversized products, this service will provide you with a Curbside delivery. If you require the product to be brought to your door, please refer to trucking delivery. This service is not available in some remote locations.
3 Days Delivery (3-5 Days):
3 Days Delivery guarantees that your package will arrive between 3 and 5 days from the date shipped. Choose this option if you need your package within a certain time period.
3 Days Trucking Delivery (3-5 Days):
3 Days Trucking Delivery guarantees that your package will arrive between 3 and 5 days from the date shipped. It is a fully insured type of shipping which includes delivery to your front door or garage and no steps are included Choose this option if you need your oversized package within a certain time period.
2nd Day Delivery (2 Days):
2nd Day Delivery guarantees that your package will arrive on the 2nd day from the date shipped. Choose this option if you need your package within a certain time period.
Next Day Delivery (1 Day):
Next Day Delivery guarantees that your package will arrive on the following day from the date shipped. Choose this option if you need your package within a certain time period.
Trucking Delivery (7-14 Days):
Trucking Delivery is a good option for your oversized package. Trucking Deliver is a fully insured type of shipping which includes delivery to your front door or garage and no steps are included. Check your delivery upon arrival. If there is any noticeable damage, refuse the delivery and note it on the airway bill. Call us immediately to report any damage.
White Glove Delivery (7-14 Days):
White Glove Delivery is a special service that is safest for large and overweight items. It is a fully insured both ways service which includes a two man delivery to the room of your choice with your product unpacked and all of the packaging debris removed. This service does not include installation of any type. Delivery includes shipment to the first floor. There will be a $15 per floor charge for any item being delivered to past the first floor. The white glove delivery time is normally between 3 and 10 business days. Our carrier of choice will contact you directly to arrange a convenient delivery time. Please inspect your item at the time of delivery. If you notice any damages, please contact our customer service department immediately.
